Filter
Top Products
8 - 50
CHAS
REAR SHOCK ABSORBER AND SWINGARM
INSTALLING THE REAR AXLE HOUSING
1.Install:
●
Rear axle housing
●
Final gear case assembly
●
Rear axle
(with dust seal)
*****************************************************
Installation steps:
●
Install the drive shaft.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
●
Apply sealant (Quick Gasket
®
) to the mating
surfaces of the swingarm and the final gear
case.
●
Temporarily install the rear axle housing 1
and final gear case assembly 2 on the
swingarm. The bolts and nuts 3 ~ 5 should
be temporarily tightened.
●
Install the rear axle (with dust seal) 6 from
the left side of the machine.
Refer to “REAR AXLE/FINAL DRIVE GEAR
AND DRIVE SHAFT” in CHAPTER 7.
●
Tighten the bolts and nuts 3 ~ 5 in the
specified order.
3
Nut (
×
4)
4
Bolt (
×
4)
5
Bolt/nut (
×
4)
*****************************************************
T
R
.
.
Nut
3
:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
®
Bolt
4
:
63 Nm (6.3 m • kg, 45 ft • lb)
LOCTITE
®
Nut
5
:
63 Nm (6.3 m • kg, 45 ft • lb)