Yamaha LIT-11616-16-02 Model Vehicle User Manual


 
7 - 24
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
Ring gear stopper clearance adjustment
1.Remove:
Ring gear 1
Ring gear stopper 2
Shim(s) 3
4
Bearing housing
È
Left-hand threads
2.Select:
Suitable shim(s)
Shim
Thickness (mm)
0.10 0.15 0.20
0.30 0.40 0.50
3.Install:
Shim(s)
Ring gear stopper (left-hand threads)
Ring gear
N
OTE:
Use LOCTITE
on the ring gear stopper.
T
R
.
.
9 Nm (0.9 m kg, 6.5 ft lb)
4.Measure:
Ring gear stopper clearance
Out of specification
Repeat adjustment
steps.
CHECKING THE REAR AXLE
1.Check:
Rear axle runout
a
Out of specification
Replace.
WARNING
Do not attempt to straighten a bent axle.
Ring gear stopper clearance:
0.30 ~ 0.60 mm (0.012 ~ 0.024 in)
Rear axle runout limit:
1.5 mm (0.06 in)