Filter
Top Products
9 - 24
– +
ELEC
CHARGING SYSTEM
OUT OF
SPECIFICATION
●
Start the engine and accelerate to about
5,000 r/min.
Charging voltage:
14 V at 5,000 r/min
N
OTE:
Use a fully charged battery.
MEETS SPECIFICATION
The charging circuit is not faulty.
EB804012
MEETS
SPECIFICATION
4.Charging coil resistance
●
Disconnect the AC magneto coupler from
the wire harness.
●
Connect the pocket tester (Ω × 1) to the
charging coils.
Tester (+) lead
→
White terminal
1
Tester (–) lead
→
White terminal
2
Tester (+) lead
→
White terminal
1
Tester (–) lead
→
White terminal
3
●
Measure the stator coil resistance.
Charging coil resistance:
0.46 ~ 0.62
Ω
at 20 °C (68 °F)
OUT OF SPECIFICATION
Replace the pickup coil/stator assembly.
EB804015
CORRECT
5.Wiring connections
●
Check the connections of the entire
charging system.
Refer to “CIRCUIT DIAGRAM”.
Replace the rectifier/regulator.
POOR CONNECTION
Properly connect the charging system.