Filter
Top Products
7 - 26
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
MEASUREMENT AND ADJUSTING THE
FINAL GEAR LASH
Final gear lash measurement
1.Secure the gear case in a vise or another
supporting device.
2.Remove:
●
Drain plug
●
Gasket
3.Install:
●
A bolt of the specified size 1
(into the drain plug hole)
CAUTION:
Finger tighten the bolt until it holds the ring
gear. Otherwise, the ring gear will be
damaged.
4.Attach:
●
Gear lash measurement tool 1
●
Dial gauge 2
a
Measuring point is 31.46 mm (1.24 in)
Gear lash measurement tool:
P/N. YM-01475, 90890-01475
5.Measure:
●
Gear lash
Gently rotate the gear coupling from
engagement to engagement
.
N
OTE:
Measure the gear lash at four positions. Rotate
the shaft 90° each time.
Final gear lash:
0.1 ~ 0.2 mm (0.004 ~ 0.008 in)