Filter
Top Products
3 - 12
CHK
ADJ
ADJUSTING THE VALVE CLEARANCE
8.Adjust:
●
Valve clearance
*****************************************************
Adjustment steps:
●
Loosen the locknut 1.
●
Insert a feeler gauge 2 between the adjuster
end and the valve end.
●
Turn the adjuster 3 clockwise or
counterclockwise with the valve adjusting
tool 4 until the proper clearance is obtained.
●
Hold the adjuster to prevent it from moving,
and then tighten the locknut.
●
Measure the valve clearance.
●
If the clearance is incorrect, repeat the above
steps until the proper clearance is obtained.
*****************************************************
Tappet adjusting tool:
P/N. YM-08035, 90890-01311
T
R
.
.
Locknut:
20 Nm (2.0 m • kg, 14 ft • lb)
9.Install:
●
All removed parts
N
OTE:
Install all removed parts in the reverse order of
their disassembly. Note the following points.
10.Install:
●
Recoil starter
●
Spark plug
●
Tappet covers
N
OTE:
Install the tappet covers with the ridge facing
up È.
LT
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • lb)
T
R
.
.
18 Nm (1.8 m • kg, 13 ft • lb)
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • lb)