Renesas R5S72625 Doll User Manual


  Open as PDF
of 2152
 
Section 17 I
2
C Bus Interface 3
Page 856 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
17.3.2 I
2
C Bus Control Register 2 (ICCR2)
ICCR2 is an 8-bit readable/writable register that issues start/stop conditions, manipulates the SDA
pin, monitors the SCL pin, and controls reset in the control part of the I
2
C bus.
76543210
01111101
R/W R/W R/W R/W R R R/W R
Bit:
Initial value:
R/W:
BBSY SCP SDAO SDAOP SCLO
-
IICRST
-
Bit Bit Name
Initial
Value R/W Description
7 BBSY 0 R/W Bus Busy
Enables to confirm whether the I
2
C bus is occupied or
released and to issue start/stop conditions in master
mode. With the clocked synchronous serial format, this
bit is always read as 0. With the I
2
C bus format, this bit
is set to 1 when the SDA level changes from high to low
under the condition of SCL = high, assuming that the
start condition has been issued. This bit is cleared to 0
when the SDA level changes from low to high under the
condition of SCL = high, assuming that the stop
condition has been issued. Write 1 to BBSY and 0 to
SCP to issue a start condition. Follow this procedure
when also re-transmitting a start condition. Write 0 in
BBSY and 0 in SCP to issue a stop condition.
6 SCP 1 R/W Start/Stop Issue Condition Disable
Controls the issue of start/stop conditions in master
mode. To issue a start condition, write 1 in BBSY and 0
in SCP. A retransmit start condition is issued in the
same way. To issue a stop condition, write 0 in BBSY
and 0 in SCP. This bit is always read as 1. Even if 1 is
written to this bit, the data will not be stored.