Renesas R5S72625 Doll User Manual


  Open as PDF
of 2152
 
Section 21 IEBus
TM
Controller
R01UH0134EJ0400 Rev. 4.00 Page 1129 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
2 RXERTME 0 R/(W)* Receive Timing Error
Set to 1 if data is not received at the time specified by
the IEBus protocol during data reception. This module
sets this bit and enters the wait state. This flag is
enabled only after the receive start flag (RXS) is set. If
this error occurs before the receive start flag (RXS) is
set, this module stops communication and enters the
wait state. This bit is not set in this case.
[Setting condition]
When a timing error occurs during data reception
[Clearing condition]
When 1 is written
1 RXEDLE 0 R/(W)* Overflow of Maximum Number of Receive Bytes in One
Frame
Indicates that the data reception has not finished within
the maximum number of bytes defined by the
communications mode because of a parity error or
overrun error causing the retransfer of data, or that
reception has not been completed because the
message length value exceeds the maximum number
of receive bytes in one frame. This module sets the
RXEDLE flag and enters the wait state. This flag is
enabled only after the receive start flag (RXS) is set. If
this error occurs before the receive start flag is set, this
module stops communication and enters the wait state.
This bit is not set in this case.
[Setting condition]
When the reception has not been completed within
the maximum number of bytes defined by
communications mode.
[Clearing condition]
When 1 is written