Renesas R5S72625 Doll User Manual


  Open as PDF
of 2152
 
Section 33 Power-Down Modes
R01UH0134EJ0400 Rev. 4.00 Page 1791 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
7 to 4 All 1 R Reserved
These bits are always read as 1. The write value
should always be 1.
3 RAMWE3 1 R/W RAM Write Enable 3 (corresponding area: page 3* in
high-speed on-chip RAM)
0: Writing to page 3 is disabled.
1 Writing to page 3 is enabled.
2 RAMWE2 1 R/W RAM Write Enable 2 (corresponding area: page 2* in
high-speed on-chip RAM)
0: Writing to page 2 is disabled.
1: Writing to page 2 is enabled.
1 RAMWE1 1 R/W RAM Write Enable 1 (corresponding area: page 1* in
high-speed on-chip RAM)
0: Writing to page 1 is disabled.
1: Writing to page 1 is enabled.
0 RAMWE0 1 R/W RAM Write Enable 0 (corresponding area: page 0* in
high-speed on-chip RAM)
0: Writing to page 0 is disabled.
1: Writing to page 0 is enabled.
Note: * For addresses in each page, see section 31, On-Chip RAM.
33.2.12 System Control Register 3 (SYSCR3)
SYSCR3 is an 8-bit readable/writable register that enables or disables access (read and write) to a
specified page in the large-capacity on-chip RAM.
When a VRAMEn (n = 0 to 5) bit is set to 1, access to page n is enabled. When a VRAMEn bit is
cleared to 0, page n cannot be accessed. In this case, an undefined value is returned when reading
data or fetching an instruction from page n, and writing to page n is ignored. The initial value of a
VRAMEn bit is 1.
SYSCR3 should be set with a program located in an area other than the large-capacity on-chip RAM. Furthermore, an
instruction to read SYSCR3 should be located immediately after the instruction to write to SYSCR3. If not, normal access
is not guaranteed.
Note: When writing to this register, see section 33.4, Usage Notes.