Renesas R5S72624 Doll User Manual


  Open as PDF
of 2152
 
Section 11 Multi-Function Timer Pulse Unit 2
Page 496 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
value R/W Description
5 N 0 R/W Reverse Phase Output (N) Control
This bit selects whether the level output or the reset-
synchronized PWM/complementary PWM output while
the reverse pins (TIOC3D, TIOC4C, and TIOC4D) are
output.
0: Level output
1: Reset synchronized PWM/complementary PWM
output
4 P 0 R/W Positive Phase Output (P) Control
This bit selects whether the level output or the reset-
synchronized PWM/complementary PWM output while
the positive pin (TIOC3B, TIOC4A, and TIOC4B) are
output.
0: Level output
1: Reset synchronized PWM/complementary PWM
output
3 FB 0 R/W External Feedback Signal Enable
This bit selects whether the switching of the output of
the positive/reverse phase is carried out automatically
with channel-0 TGRA, TGRB, TGRC input capture
signals or by writing 0 or 1 to bits 2 to 0 in TGCR.
0: Output switching is external input (Input sources are
channel 0 TGRA, TGRB, TGRC input capture signal)
1: Output switching is carried out by software (setting
values of UF, VF, and WF in TGCR).
2 WF 0 R/W Output Phase Switch 2 to 0
These bits set the positive phase/negative phase output
phase on or off state. The setting of these bits is valid
only when the FB bit in this register is set to 1. In this
case, the setting of bits 2 to 0 is a substitute for external
input. See table 11.37.
1 VF 0 R/W
0 UF 0 R/W