Renesas R5S72624 Doll User Manual


  Open as PDF
of 2152
 
Section 7 Interrupt Controller
Page 206 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
7.9 Data Transfer with Interrupt Request Signals
Interrupt request signals can be used to activate the direct memory access controller and transfer
data.
Interrupt sources that are designated to activate the direct memory access controller are masked
without being input to the interrupt controller. The mask condition is as follows:
Mask condition = DME (DE0 interrupt source select 0 + DE1 interrupt source select 1
+ DE2 interrupt source select 2 + DE3 interrupt source select 3 +
DE4 interrupt source select 4 + DE5 interrupt source select 5 + DE6
interrupt source select 6 + DE7 interrupt source select 7 + DE8
interrupt source select 8 + DE9 interrupt source select 9 + DE10
interrupt source select 10 + DE11 interrupt source select 11 + DE12
interrupt source select 12 + DE13 interrupt source select 13 + DE14
interrupt source select 14 + DE15 interrupt source select 15)
Figure 7.13 shows a block diagram of interrupt control.
Here, DME is bit 0 in DMAOR of the direct memory access controller, and DEn (n = 0 to 15) is
bit 0 in CHCR_0 to CHCR_15 of the direct memory access controller. For details, see section 10,
Direct Memory Access Controller.
Direct memory
access
controller
Interrupt
controller
CPU
CPU interrupt request
Interrupt source
Interrupt source (not specified as a direct memory access controller activating source)
Interrupt source
flag clearing
(by the direct memory
access controller)
Figure 7.13 Interrupt Control Block Diagram