Renesas R5S72624 Doll User Manual


  Open as PDF
of 2152
 
Section 9 Bus State Controller
Page 342 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
9.5.7 Burst ROM (Clocked Asynchronous) Interface
The burst ROM (clocked asynchronous) interface is used to access a memory with a high-speed
read function using a method of address switching called the burst mode or page mode. In a burst
ROM (clocked asynchronous) interface, basically the same access as the normal space is
performed, but the 2nd and subsequent access cycles are performed only by changing the address,
without negating the RD signal at the end of the 1st cycle. In the 2nd and subsequent access
cycles, addresses are changed at the falling edge of the CKIO.
For the 1st access cycle, the number of wait cycles specified by the W3 to W0 bits in CSnWCR is
inserted. For the 2nd and subsequent access cycles, the number of wait cycles specified by the
BW1 and BW0 bits in CSnWCR is inserted.
In the access to the burst ROM (clocked asynchronous), the BS signal is asserted only to the first
access cycle. An external wait input is valid only to the first access cycle.
In the single access or write access that does not perform the burst operation in the burst ROM
(clocked asynchronous) interface, access timing is same as a normal space.
Table 9.15 lists a relationship between bus width, access size, and the number of bursts. Figure
9.33 shows a timing chart.
Table 9.15 Relationship between Bus Width, Access Size, and Number of Bursts
Bus Width Access Size CSnWCR. BST[1:0] Bits Number of Bursts Access Count
8 bits 8 bits Not affected 1 1
16 bits Not affected 2 1
32 bits Not affected 4 1
16 bytes 00 16 1
01 4 4