Filter
Top Products
Troubleshooting 6-3MN1921
Axis disabled. The axis/drive must be enabled before operation can continue. See
section 5.4.1. Click the Drive enable button in WorkBench v5.
Suspend. The SUSPEND command has been issued and is active. Motion will be
ramped to zero demand whilst active.
Reverse software or hardware limit. A reverse software limit has been activated.
See AXISERROR and/or AXISSTATUS to determine which applies.
Forward software or hardware limit. A forward software limit has been activated.
See AXISERROR and/or AXISSTATUS to determine which applies.
Firmware being updated (horizontal bars appear sequentially). New firmware is being
downloaded to the NextMove ST.
Initialization error. An initialization error has occurred at power on. See the Error Log or
INITERROR topics in the help file. Initialization errors should not normally occur.
When a node number between 1 and 15 is displayed, it is shown in hexadecimal format (1 - F).
For node numbers greater than 15, three horizontal bars are displayed. User defined symbols
can be made to appear using the LED and LEDDISPLAY keywords.
See the MintMT help file for details of each keyword.
6.2.2 Surface mount LEDs D3, D4 and D16
The NextMove ST control card contains a number of surface mount LEDs that indicate
hardware status:
D3 (yellow):
Indicates that the FPGA is being initialized at startup.
D4 (red):
Indicates that the card is in hardware reset. If this LED
remains illuminated after power up, the supply voltage to
the card is too low. Check power supply connections.
D16 (flashing green):
Flashes at 0.5Hz to indicate normal operation.
D3
D4
D16