Filter
Top Products
5-2 Operation MN1921
5.1.5 Power on checks
If at any time the status display shows a digit and a flashing decimal point, this indicates that
the NextMove ST has detected a fault - see section 6.
1. T urn on the Logic supply (if separate from the Drive supply).
2. T urn on the Drive supply.
3. After a brief test sequence, (
followed by ), the St atus display should show the node
number, for example
, the factory default. If the display is not lit then re-check t he power
supply connections. A green surface mount LED (D16) near the center of the control card
should also be flashing once every two seconds. The NextMove ST is now ready to be
configured using WorkBench v5.
Note: If the red LED (D4) near the center of the control card remains illuminated, then
the supply voltage to the NextMove ST control card is too low. See section 6.2.2
for LED locations.