Filter
Top Products
Basic Installation 3-1MN1921
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove ST.
This section describes the mechanical installation of the NextMove ST.
3.1.1 L ocation requirements
You must read and understand this section before beginning the installation.
CAUTION: To prevent equipment damage, be certain that input and output signals
are powered and referenced correctly .
CAUTION: To ensure reliable performance of this equipment be certain that all
signals to/from the NextMove ST are shielded correctly .
CAUTION: Avoid locating the NextMove ST immediately above or beside heat
generating equipment, or directly below water steam pipes.
CAUTION: Avoid locating the NextMove ST in the vicinity of corrosive substances or
vapors, metal particles and dust.
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
H The NextMove ST is designed to be mounted indoors, permanently fixed and located.
H The NextMove ST must be secured by the slots in the metal carrier.
H The NextMove ST must be installed in an ambient temperature of 0°C to 40°C (32°F to
104°F).
H The NextMove ST must be installed in relative humidity levels of less than 80% for
temperatures up to 31°C (87°F) decreasing linearly to 50% relative humidity at 40°C
(104°F), non-condensing.
H The NextMove ST must be installed where the pollution degree according to IEC664 shall
not exceed 2.
H There shall not be abnormal levels of nuclear radiation or X-rays.
3 Basic Installation
3