Filter
Top Products
Advanced Techniques
Setting Parameters using Menu Mode
74
DTX502 Owner’s Manual
System3 Master Equalizer
q Lo
The drum module features a two-band shelving equalizer as
its master EQ. Use this parameter to set the equalizer’s low-
end gain in dB. The higher the value, the more the low end
will be boosted.
w Hi
Use this parameter to set the master equalizer’s high-end gain
in dB. The higher the value, the more the high end will be
boosted.
System4
Master Tuning
q Tune
Use this parameter to set the tuning for songs in steps of one
cent.
System5
Local Control
q LocalCtrl
Use this parameter to enable (“on”) or disable (“off”) playing
of the internal tone generator using the pads and songs. When
set to “off”, the tone generator is essentially disconnected
from the pads and controllers, which will be unable to gener-
ate any sound.
System6
Metronome Output
q OutSel
Use this parameter to specify where metronome sounds are to
be output.
System7
Number Display Function
q Disp
Use this parameter to specify what is to be shown by the
number display.
Settings
0 to +12
Settings
0 to +12
Settings
-100 to +100
NOTE
The above parameter has no effect on drum kit sounds.
Settings
off or on
>Sys
t
em3 MEQ
”Lo=+ 2 Hi=+ 2 ‚
wq
>Sys
t
em4 Mtune
” tune=+ 0 ‚
q
>Sys
t
em5
”LocalC
t
rl=on ‚
q
Settings Description
mix
The metronome is routed to the OUTPUT [L/
MONO] and [R] jacks.
clickL
The metronome is routed to the OUTPUT [L/
MONO] jack only; drum and song sounds
are output in mono via the OUTPUT [R]
jack.
clickR
The metronome is routed to the OUTPUT
[R] jack only; drum and song sounds are
output in mono via the OUTPUT [L/MONO]
jack.
NOTE
The above setting also applies to output from the [PHONES]
jack.
Settings Description
tempo Current tempo
mode
Mode-specific content as follows.
• Kit area: Kit number
• Training Mode: Current tempo
• Song area: Song number
• Recording: Current tempo
• Metronome area: Click Set number
(current tempo on Tap Tempo page
only)
•Menu Mode: No display (trigger setup
number in Trigger area only)
• All other times: No display
timer
Metronome timer. Training timer when in
Training Mode.
NOTE
In cases where the above parameter is not set to “tempo”, the
number display will show the tempo for several seconds after it is
changed by one of the following actions.
•Turning the Data Dial with the [SHIFT] bu tton held down
• Operating a pad controller whose function has been set to
“tempo” (page 62)
• Striking a pad whose pad function has been set to “inc
tempo”, “dec tempo”, or “tap tempo” (page 66)
>Sys
t
em6 Click
”Ou
t
Sel=mix ‚
q
>Sys
t
em7 LED
” Disp=
t
empo ‚
q