Filter
Top Products
Basic Techniques
Performing with a Song
30
DTX502 Owner’s Manual
5.
If necessary, move the cursor to the voice category
using the [<]/[>] buttons.
6.
Turn the Data Dial to select “ e ” (pad song) as the
voice category.
7.
Move the cursor to the song number using the [<]/
[>] buttons.
8.
Turn the Data Dial to choose a pad song.
See the Data List section (page 83) for details of the available pad songs.
Setting Repeat and Play modes
Setting the pad song’s Repeat mode
1.
Move the cursor to the Repeat mode symbol using
the [<]/[>] buttons.
2.
Turn the Data Dial to change the mode setting.
: Normal play
: Repeat play—that is, the song starts again from the beginning after
playing to the end
Setting the pad song’s Play mode
1.
Move the cursor to the Play mode symbol using
the [<]/[>] buttons.
2.
Turn the Data Dial to change the mode setting.
: The pad song will start or stop accordingly whenever the pad is struck.
: The pad song will play one measure at a time whenever the pad is
struck.
: If any other pad song of the same type is already playing, it will be
stopped before playing the pad song selected here.
KIt2 snareHd
”S01:MapleCus
t
m‚
KIt2* snareHd
”Ö01:Demo ≥‚
KIt2* snareHd
”Ö01:Demo ≥‚
NOTE
• Pad songs are played back inde-
pendent of the main song selected
on the SONG1 page.
• Pad songs cannot be played when
recording a song or when practicing
in Training Mode.
KIt2* snareHd
”Ö39:Funk C ≥‚
Repeat mode Play mode
≥
μ
Â
Ê
Á