Filter
Top Products
Advanced Techniques
DTX502 Owner’s Manual
Setting Parameters using Menu Mode
65
KitJ2 Clear User Kit
On the Clear User Kit page, you can restore a User kit to its
default settings.
1. Navigate to the Clear User Kit page and specify which of the
User kits (numbered 51 to 100) is to be cleared.
2. Press the [SAVE/ENTER] button.
You will be asked to confirm that you wish to clear the User
kit.
Press the [SAVE/ENTER] button once again to clear the
User kit. To cancel the process without clearing any settings,
press the [ ] button.
3. When the User kit has been successfully cleared, the mes-
sage “Completed.” will be displayed.
Pad1
Hi-hat Splash Sensitivity
q Splash
Use this parameter to set the degree of sensitivity for detect-
ing hi-hat foot splashes. The higher the value, the easier it
will be to produce a foot-splash sound with the hi-hat control-
ler. High values may, however, result in splash sounds being
unintentionally produced when, for example, you operate the
hi-hat controller lightly as you keep time. It is a good idea to
set this parameter to “off” if you do not want to play foot
splashes.
Pad2
Foot Close Position
q ClosePos
Use this parameter to adjust the position at which the hi-hat
switches from open to closed when the hi-hat controller is
depressed. The lower the value, the smaller the virtual open-
ing between the top and bottom hi-hats.
CAUTION
When a User kit is cleared, all of its settings will be
returned to their default conditions. Before proceeding,
therefore, you should ensure that the User kit in ques-
tion contains no irreplaceable settings.
>Ki
t
J2 Clear
”51:User Ki
t
>Ki
t
J2 Clear
”51:User Ki
t
User kit number
>Ki
t
J2 Clear
Are you sure?
05: Pad Area
Pad-related settings
Settings
off, 1 to 127
Settings
0 to 32
>Pad1
” Splash= 30 ‚
q
>Pad2
” ClosePos=28 ‚
q