Filter
Top Products
Advanced Techniques
DTX502 Owner’s Manual
Setting Parameters using Menu Mode
57
The Mixer area is used to adjust the volumes of the various drum
kit voices.
MIXER Mixer settings
q Volume
Use the volume parameters to balance the input group* vol-
umes.
Input group indicators
H: Hi-hat sound volumes
S: Snare sound volumes
K: Kick sound volumes
T: Tom sound volumes
C: Cymbal sound volumes
R: Degree to which reverb is applied
Use the [<]/[>] buttons to select an input group, and then
turn the Data Dial to adjust its volume. Faders are displayed
above each of the input-group indicators to give a general
idea of the current volume balance. The reverb (R) setting
applies to all of the drum kit’s voices.
The KitVoice area is used to set drum voices for individual trigger
input sources.
KitV1
Layers
q Trigger input source
This item indicates the trigger input source currently selected
for editing. Trigger input sources can be selected by striking
the corresponding pad or zone. This selection applies to both
Layer A and Layer B. (Trigger input sources are not dis-
played individually for each layer.)
01: Mixer Area
Mixer settings
NOTE
*: Input groups
Voices are organized into input groups based on their voice
category. For example, when you change the T setting (tom
sound volumes), the volume of all sounds from the Tom (T)
voice category will change accordingly.
Settings
0 to 16
>MIXER ÏÏÏÏÏÈ
” Kick=16 HSKtCR
q
02: KitVoice Area
Settings affecting individual voices
NOTE
Yo u can also select trigger input sources by holding down the
[SHIFT] button and pressing the [<]/[>] buttons.
Settings
snareHd, snareOp, snareCl, snrOfHd,
snrOfOp, snrOfCl, tom1Hd, tom2Hd, tom3Hd,
rideBw, rideEg, rideCp, crashBw, crashEg,
crashCp, kick, pad8, hhOpBw, hhOpEg,
hhOpCp, hhClBw, hhClEg, hhClCp, hhFtCl,
hhSplsh, pad10, pad11, pad12, and kick2
For details on the correspondence between
trigger input jacks and trigger input sources,
refer to page 29.
>Ki
t
V1 snareHd
”Layer=s
t
ack ‚
q
w