Filter
Top Products
Advanced Techniques
Setting Parameters using Menu Mode
72
DTX502 Owner’s Manual
The Training area is used to set training-function parameters.
Trng1
Timer
q Timer
Use this parameter to set the practice timer used in Training
Mode. The timer is started at the beginning of practice, and
when it reaches the set time, the practice session will end
automatically.
Trng2
Difficulty Level
q Difficulty
Use this parameter to set the training difficulty level. The
larger the setting, the more difficult the training.
Trng3
Ignore Timing
q IgnrTiming
Use this parameter to specify whether or not the pads are to
produce sounds when played out of time. When set to “on”,
they will always produce a sound.
Trng4
Pad Gate Group
q Group
Use this parameter to set which groups of pads the drum
module should consider when deciding whether or not you
are playing the song’s drum pattern correctly in Pad Gate
training (page 46).
07: Training Area
Training-related settings
Settings
off, 30s, 60s, 90s, 120s, 150s, 180s, 300s,
480s, and 600s
NOTE
The above setting applies only to the following types of training.
•Groove Check
•Rhythm Gate
•Measure Break
• Tempo Up/Down
• Change Up
•Pad Gate
Settings
1 to 5
NOTE
The above setting applies only to the following types of training.
• Tempo Up/Down
• Change Up
•Pad Gate
>trng1
” timer=off ‚
q
>trng2
” Difficul
t
y=3 ‚
q
Settings
off or on
NOTE
The above setting applies only to the following types of training.
• Tempo Up/Down
• Change Up
•Pad Gate
Settings Description
all pads
Any pad will be scored, as long as the timing
of your drumming is correct.
group1
The kit is separated into five groups—kick,
snare, toms, cymbals, and hi-hat. In order
for your drumming to be scored, you must
strike pads from the same group as those
from the practice drum pattern and do so in
time.
group2
Similar to “group 1”, but all toms and cym-
bals are treated separately. In addition, the
hi-hat pad and the hi-hat controller are also
divided into separate groups.
all note
With this setting, you must play the drum
pattern exactly as it is in the song.
NOTE
The above setting applies only to Pad Gate training.
>trng3
”Ignrtiming=off‚
q
>trng4
”Group=group1 ‚
q