Filter
Top Products
Advanced Techniques
DTX502 Owner’s Manual
Setting Parameters using Menu Mode
63
KitC8 Trigger Setup Link
q TrgSetupLk
Use this parameter to assign a trigger setup to the currently
selected kit. Select “off” if the kit does not need a specific
trigger setup.
KitC9
MIDI Program Change
On the MIDI Program Change page, you can specify the MIDI
Program Change number to be sent when the current kit is
selected, in addition to the corresponding Bank Select MSB and
LSB messages.
q MIDI channel (Ch)
Use this parameter to set the MIDI channel on which to send
the Program Change messages.
w Program-change output switch
Use this parameter to turn the output of Program Change
messages on or off.
e Program change number
Use this parameter to set the Program Change number to be
sent.
r Bank Select MSB
t Bank Select LSB
KitC10
MIDI Control Change
On the MIDI Control Change page, you can set values for MIDI
Control Change volume and pan messages to be sent when the
current kit is selected.
q MIDI channel (Ch)
Use this parameter to set the MIDI channel on which to send
the Control Change messages.
w Control Change output switch
Use this parameter to turn the output of Control Change mes-
sages on or off.
e Volume
Use this parameter to set a value for the Control Change vol-
ume message.
r Pan
Use this parameter to set a value for the Control Change pan
message.
Settings
off, 01 to 30
NOTE
By sending MIDI Program Change messages, you can have the MIDI
instrument automatically change its voice when you select the cur-
rent kit.
Settings
1 to 16
Settings
off or on
Settings
001 to 128
Settings
000 to 127
NOTE
In order to set the Bank Select MSB and LSB parameters cor-
rectly, you will need to refer to the MIDI instrument’s Voice List
and MIDI Data Format.
>Ki
t
C8
”trgSe
t
upLk=off‚
q
>Ki
t
C9 Ch1=off
”PC001 M000L000‚
te r
q
w
NOTE
By sending these MIDI Control Change messages, you can have the
MIDI instrument connected via the MIDI OUT connector automati-
cally set its volume and stereo panning when you select the current
kit.
Settings
1 to 16
Settings
off or on
Settings
0 to 127
Settings
L64 to C to R63
>Ki
t
C10 Ch1=off
”Vol=100 Pan= C
e r
q
w