Renesas R5S72644 Doll User Manual


  Open as PDF
of 2152
 
Section 9 Bus State Controller
R01UH0134EJ0400 Rev. 4.00 Page 241 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
5 DMAIWA 0 R/W Method of inserting wait states between access
cycles when DMA single address transfer is
performed.
Specifies the method of inserting the idle cycles
specified by the DMAIW[2:0] bit. Clearing this bit will
make this LSI insert the idle cycles when another
device, which includes this LSI, drives the data bus
after an external device with DACK drove it. However,
when the external device with DACK drives the data
bus continuously, idle cycles are not inserted. Setting
this bit will make this LSI insert the idle cycles after an
access to an external device with DACK, even when
the continuous access cycles to an external device
with DACK are performed.
0: Idle cycles inserted when another device drives the
data bus after an external device with DACK drove
it.
1: Idle cycles always inserted after an access to an
external device with DACK
4 1 R Reserved
This bit is always read as 1. The write value should
always be 1.
3, 2 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.
1 HIZMEM 0 R/W High-Z Memory Control
Specifies the pin state in software standby mode or
deep standby mode for A25 to A0, BS, CSn, CS2x,
RD/WR, WEn/DQMx/AH, and RD. At bus-released
state, these pin are high-impedance states regardless
of the setting value of the HIZMEM bit.
0: High impedance in software standby mode or deep
standby mode.
1: Driven in software standby mode or deep standby
mode