Renesas R5S72644 Doll User Manual


  Open as PDF
of 2152
 
Section 26 USB 2.0 Host/Function Module
R01UH0134EJ0400 Rev. 4.00 Page 1523 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
condition as when BVAL = 1). Whether to sample the DMA transfer end signal can be specified
through the TENDE bit in DnFBCFG.
Note that this function cannot be used when the DMA transfer size is set to 16 bytes.
(c) DnFIFO Auto Clear Mode (D0FIFO/D1FIFO Port Reading Direction)
If 1 is set for the DCLRM bit in DnFIFOSEL, the module automatically clears the buffer memory
of the selected pipe when reading of the data from the buffer memory has been completed.
Table 26.25 shows the packet reception and buffer memory clearing processing for each of the
various settings. As shown, the buffer clear conditions depend on the value set to the BFRE bit.
Using the DCLRM bit eliminates the need for the buffer to be cleared even if a situation occurs
that necessitates clearing of the buffer. This makes it possible to carry out DMA transfers without
involving software.
This function can be set only in the buffer memory reading direction.
Table 26.25 Packet Reception and Buffer Memory Clearing Processing
Buffer Status
When Packet is Received
Register Setting
DCLRM 0 DCLRM 1
BFRE = 0 BFRE = 1 BFRE = 0 BFRE = 1
Buffer full Doesn't need
to be cleared
Doesn't need
to be cleared
Doesn't need
to be cleared
Doesn't need
to be cleared
Zero-length packet reception Needs to be
cleared
Needs to be
cleared
Doesn't need
to be cleared
Doesn't need
to be cleared
Normal short packet reception Doesn't need
to be cleared
Needs to be
cleared
Doesn't need
to be cleared
Doesn't need
to be cleared
Transaction count ended Doesn't need
to be cleared
Needs to be
cleared
Doesn't need
to be cleared
Doesn't need
to be cleared