Renesas R5S72640 Doll User Manual


  Open as PDF
of 2152
 
Section 25 NAND Flash Memory Controller
Page 1306 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
25.3.8 Interrupt DMA Control Register (FLINTDMACR)
FLINTDMACR is a 32-bit readable/writable register that enables or disables DMA transfer
requests or interrupts. A transfer request from this module to the direct memory access controller
is issued after each access mode has been started.
Bits 9 to 5 are the flag bits that indicate various errors occurred in flash memory access and
whether there is a transfer request from the FIFO. Only 0 can be written to these bits. To clear a
flag, write 0 to the target flag bit and 1 to the other flag bits.
Bit:
Initial value:
R/W:
Bit:
Initial value:
R/W:
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
151413121110987654321
0
0000000000000000
RRRRRRRR/WRRR/WR/WR/WR/WR/WR/W
0000000000000000
RRRRRRR/(W)*R/(W)*R/(W)*R/(W)*R/(W)* R/W R/W R/W R/W R/W
------
4ECE
INTE
ECER
INTE
--
FIFOTRG
[1:0]
AC1
CLR
AC0
CLR
DREQ1
EN
DREQ0
EN
------
EC
ERB
ST
ERB
BTO
ERB
TRR
EQF1
TRR
EQF0
STER
INTE
RBER
INTE
TE
INTE
TR
INTE1
TR
INTE0
Bit Bit Name
Initial
Value R/W Description
31 to 26 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.
25 4ECEINTE 0 R/W 4-Symbol ECC Pattern Generation End Interrupt
Enable
Enables or disables an interrupt to CPU by 4-symbol
ECC pattern generation end.
0: Disables an interrupt to CPU by 4-symbol ECC
pattern generation end.
1: Enables an interrupt to CPU by 4-symbol ECC
pattern generation end.
24 ECERINTE 0 R/W ECC Error Interrupt Enable
Enables or disables an interrupt to CPU when ECC
error occurs.
0: Disables an interrupt to CPU when an ECC error
occurs
1: Enables an interrupt to CPU when an ECC error
occurs