Filter
Top Products
8 SPAN-IGM User Manual Rev 2
Notices
The following notices apply to the SPAN-IGM.
FCC Notices
This SPAN device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This SPAN device has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Industry Canada
SPAN Class A digital apparatuses comply with Canadian ICES-003.
SPAN appareils numérique de la classe A sont conforme à la norme NMB-003 du Canada.
CE Notice
The enclosures carry the CE mark.
"Hereby, NovAtel Inc. declares that this SPAN-IGM is in compliance with the essential requirements and
other relevant provisions of the R&TTE Directive 1999/5/EC, the EMC Directive 2004/108/EC and of the
RoHS Directive 2011/65/EU."
WEEE Notice
If you purchased your SPAN product in Europe, please return it to your dealer or supplier at the end of its
life. The objectives of the European Community's environment policy are, in particular, to preserve,
protect and improve the quality of the environment, protect human health and utilise natural resources
prudently and rationally. Sustainable development advocates the reduction of wasteful consumption of
natural resources and the prevention of pollution. Waste electrical and electronic equipment (WEEE) is a
regulated area. Where the generation of waste cannot be avoided, it should be reused or recovered for
its material or energy. WEEE products may be recognized by their wheeled bin label ( ).
1
In order to maintain compliance with the limits of a Class A digital device, it is required to
use properly shielded interface cables (such as Belden #9539 or equivalent) when using
the serial data ports, and double-shielded cables (such as Belden #9945 or equivalent)
when using the I/O strobe port.
Changes or modifications to this equipment, not expressly approved by NovAtel Inc., could
result in violation of FCC, Industry Canada and CE Marking rules and void the user’s
authority to operate this equipment.