Filter
Top Products
4 Message Formats
MiLLennium GPSCard Software Version 4.50 Command Descriptions Manual Rev 1 57
COM1> log com2 rinex ontime 30
(some time later - move to a new site)
COM1> log com2 xkin
COM1> rinex markernum 980.1.35
COM1> rinex antdh 3.1
(at new site)
COM1> log com2 xsta
(some time later - logging complete)
COM1> unlogall
It should be noted that the first line of this example is equivalent to these two lines:
COM1> log com2 xobs ontime 30
COM1> log com2 xnav onchanged
The use of the pseudo-log RINEX is for convenience only.
After the UNLOGALL command, the XNHD and XOHD logs are automatically generated if XNAV and XOBS,
respectively, were active.
4.4.1 COMMANDS
RINEX
This command is used to configure the user-defined fields in the file headers.
The settings of all these fields are visible in the
RCCA log. All settings can be saved to non-volatile memory on a
MiLLennium card by the
SAVECONFIG command. A CRESET command will empty all text fields and reduce to
zero the antenna offsets.
Syntax:
RINEX cfgtype
Command Range Values Description
RINEX - Command
cfgtype AGENCY Define agency name in observation log header
ANTDE Define antenna delta east (offset to marker) in observation log and static event log
ANTDH Define antenna delta height (offset to marker) in observation log and static event log
ANTDN Define antenna delta north (offset to marker) in observation log and static event log
ANTNUM Define antenna number in observation log header
ANTTYPE Define antenna type in observation log header
COMMENT Add comment to navigation and observation log headers (optional)
MARKNAME Define marker name in observation log and static event log
MARKERNUM Define marker number in observation log (optional) and static event log
OBSERVER Define observer name in observation log header
RECNUM Define receiver number in observation log header