Mitsubishi Electronics XD8600 Crib Toy User Manual


  Open as PDF
of 79
 
EN-67
Automatic cleaning filter
This projector is equipped with an automatic cleaning
filter. The burdensome filter cleaning is automatically
carried out.
• Whenthepoweroftheprojectorison,thelteris
cleaned after the designated time elapses.
• When the cumulative operation time since the
last cleaning of the automatic cleaning filter
exceeds the designated time, the filter is cleaned
automatically after you turn off the projector by
pressing the POWER button.
Important:
• When the cumulative operation time has exceeded
the designated time and you run the projector
continuously for 24 hours after turning on the
power, the automatic cleaning filter works while the
projector is operating.
Setting the cleaning interval
You can set the cleaning interval of the automatic
cleaning filter using the menu.
(See page 31 for menu setting.)
1. Display the INSTALLATION 2 menu.
2. Select FILTER MENU by pressing the or
button.
FILTER MENU
ENTER
3. Press the ENTER button.
4. Select CLEANUP PERIOD by pressing the or
button.
CLEANUP PERIOD
1 WEEK
5. Select 24H
or 1 WEEK
by pressing the or
button.
24H
.............The filter is cleaned about every 24
hours.
1 WEEK
.......The filter is cleaned about every 168
hours.
6. Press the ENTER button.
• When you select 24H
or 1 WEEK , the box
to set the cleaning interval is displayed.
24H
NEXT CLEANUP
24H
0
OK
CLEAR
DEL
CANCEL
1234567 8 9
← →
1 WEEK
NEXT CLEANUP
7D 00H
0
OK
CLEAR
DEL
CANCEL
1234567 8 9
← →
7. Move the key cursor using the direction buttons to
select the number you want to enter and then press
the ENTER button.
• Maximuminterval
24H ........... 24H (about 24 hours)
1 WEEK .... 7D 00H (about 168 hours)
← key: Shifting the position of enter cursor
to the left for each character.
→ key: Shifting the position of enter cursor
to the right for each character.
DEL key: Deleting the character in the
position of enter cursor for each
character.
CLEAR key: Deleting all the entered characters.
• Youcanenterthevaluebypressingthenumber
buttons (0 to 9) while holding down the NUM
button on the remote control.
• Whenthevalueyouenteredmeetsthefollowing
conditions, an error dialog box is displayed at
the screen center for 3 seconds.
∙ The value has been cleared by DEL or CLEAR
and left blank.
∙ The value you entered is out of the setting
range.
24H ......... 25H or over
1 WEEK ... 7D 01H or over
∙ The value of each item is out of the setting
range.
D .................. 8 or over (1 WEEK only)
H .................. 25 or over
8. Select OK to accept the interval you entered and
exit the menu, or select CANCEL to exit the menu
without saving the setting.
• WhenyouselectOKorCANCEL,theCLEANUP
PERIOD menu is displayed.
 previous next