Filter
Top Products
EN-24
Viewing video images
Connecting to a video player, etc.
1. Connect one end of a commercially available BNC cable to
the VIDEO IN terminal of the projector.
2. Connect the other end of the BNC cable to the video
output terminal of the video equipment.
When the video equipment is equipped with the S-video
output terminal, make the connection as follows:
1. Connect one end of a commercially available S-video cable
to the S-VIDEO IN terminal of the projector.
2. Connect the other end of the S-video cable to the S-video
output terminal of the video equipment.
• Alsoreadtheinstructionmanualoftheequipmenttobeconnected.
• Contactyourdealerfordetailsofconnection.
When a TV tuner or VCR is connected:
When you use this projector with a TV tuner or VCR connected, no image may appear or a message of “NO SIGNAL”
may appear on the screen when you change the channel via any channel that is not being received. In such a case,
set the channels of the TV tuner or VCR again. To avoid such symptom, use the TV tuner or VCR with its channel skip
function (that is a function not to display channels that are not being received) enabled.
A. Connecting the projector to video equipment
Preparation:
• Make sure that the power of the projector and that of the video equipment are turned off.
1
2
To S-VIDEO
IN terminal
S-video cable (option)
To S-video
output
terminal
Video player, or the like
1
To VIDEO IN
terminal (BNC)
BNC cable (option)
To video output
terminal
Video player, or the like
BNC-RCA
connector (option)