Mitsubishi Electronics A1SD75M1/M2/M3 Model Vehicle User Manual


 
11 - 42 11 - 42
MELSOFT
11. POSITIONING DEBUGGING
DISPLAY/SETTING DATA
Item Description
MPG selection Shows the data set to MPG selection of the extended parameters 1 (refer to Section 8.1.3).
Manual pulse generator
factor
Set the multiplying factor per pulse input from the manual pulse generator for MPG
operation.
"Enab/Disab" button Click this button to enable/disable MPG operation.
"#1 stop" button
"#2 stop" button
"#3 stop" button
Click the corresponding button to disable the axis which has been enabled for MPG
operation.
Reset the error after a stop since the axis results in an error occurrence status.
"All stop" button
Click this button to disable all axes that have been enabled for MPG operation.
Reset the error after a stop since the axis results in an error occurrence status.
"Error reset" button
(
/
/ )
Click any button to reset the error of the corresponding axis.
"M code Off" button
(
/
/ )
Click any button to turn off the M code ON signal (XD, XE, XF) of the corresponding axis.