A SERVICE OF

logo

Configuring Ports
This chapter describes how to configure ports on the Intel
®
NetStructure
480T routing switch and covers these topics:
Configuring Ports
Changing Port Speed and Duplex Settings
Jumbo Frames
Load Sharing
Jumbo Frames
Port-Mirroring
Enterprise Discovery Protocol
Configuring Ports
By default, all ports are enabled. To enable or disable one or more ports,
use this command:
[enable | disable] ports <portlist>
For example, to disable ports 3, 5, and 12 through 15 on the switch, enter
this:
disable port 3,5,12-15
Even though a port is disabled, the link remains enabled for diagnostic
purposes.
6