Filter
Top Products
35
Install your SS/CS Series hopper loader, apply power, press the
S
START/STOP
START/STOP key and
operation begins. The hopper loader loads itself until full, then dumps and repeats, pausing
only when the machine bin below it is full.
The screen displays the vacuum timer while the vacuum motor is on. If the hopper loader is a
PP proportioning model, follow the instructions in Section 5-6 below.
Stop your hopper loader at any time by pressing the
S
START/STOP
START/STOP key.
5-6 Operating the Proportioning Feature
Series One Plus Models Only
The proportioning feature allows layering of two materials in the machine bin below the
hopper loader. Install the hopper loader and put both the material pickup wands in the material
supply gaylords and follow the instructions that follow.
Adjusting Proportioning While the Hopper Loader is in Standby Mode
1. When the standby mode displays, press the
SCROLL
SCROLL key
until the Proportioning Menu displays as
3
.
2. Press the
S
START/STOP
START/STOP/SELECT/SET key to access
Menu 3.
The current percentage of Material B displays.
3. Press the
UP key or the DOWN key to change the setting
as needed.
4. When the percentage of Material B you want displays, press the
S
START/STOP
START/STOP/ SELECT/SET key to set it.
- or -
Press the
SCROLL
SCROLL key to leave the menu unchanged.