Filter
Top Products
32
Note: You can adjust the maximum vacuum time from 0 to 360
seconds. See Section 5-11, Menu 1.
When the proximity sensor trips or sixty (60) seconds elapses, the
vacuum motor shuts off for three (3) seconds to relieve vacuum in
the hopper and to allow the material to dump.
The BLOWBACK LED flashes and the screen displays
----
as a four (4) -pulse blowback cycle occurs.
Note: You can adjust number of blowback pulses from 0 to 16 pulses.
See Section 5-11, Menu 2.
The conveying cycle repeats automatically until the Bin Full
switch senses that the material receiver (machine hopper) is full.
The hopper loader stops in Standby mode and the screen displays
FULL
until the machine bin level drops and automatic operation
resumes.
Notes: • If the Series One Plus screen displays the
Er. 1
No Convey
error code and shuts down after three (3) conveying cycles,
but you do not have a material supply problem, then you
need to lengthen the maximum vacuum time to fill the
hopper sufficiently to trigger the proximity sensor. See
Section 5-11, Menu 1.
• The maximum number of consecutive unsuccessful
conveying cycles before an alarm condition occurs
is adjustable from 0 to 8 cycles. See Section 5-11, Menu 5.
First Time Startup for Proportioning Models
1. Insert the pickup wand into the material supply.
2. Turn on the compressed air to the hopper loader.
3. Apply power to the controller.