Filter
Top Products
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Pre LPF
Ring Modulator
Pre LPF
Ring Modulator
Note No.
OSC Mode
Fixed
Note (Key Follow)
Fixed Frequency
Pitch
Note Offset, Fine
Oscillator
LFO
microKORG XL
78
DRY/WET ......................................................["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
OSC MODE ..........................................................................[FIXED, NOTE]
Switching between specifying the oscillator frequency and using a note
number.
If this is set to NOTE, the oscillator frequency will track the note of the input
signal.
FIXD.FREQ (Fixed Frequency) ..................................... [0Hz…12.0kHz]
This parameter sets the oscillator frequency when “OSC MODE” is set to
FIXED.
If this parameter is assigned to “CTRL-1,” or “CTRL-2,” setting “OSC
MODE” to NOTE will switch the assignme
nt to NOTE.OFST.
NOTE.OFST (Note Offset) ..................................................[–48…+48]
Sets the pitch difference from the original note in semitone steps when
“OSC MODE” is set to NOTE.
NOTE.FINE.......................................................................[–100…+100]
Sets the pitch difference from the original note in cent steps when “OSC
MODE” is set to NOTE.
NOTE
By setting “NOTE.OFST” and “Note.Fine” so that the oscillator frequency
will track the note that is input, you can produce a ring modulator effect
with a correct scale.
OSC WAVE (OSC Waveform) .................................... [SAW, TRIANGLE, SINE]
Selects the ocsillator waveform.
LFO INT (LFO Intensity) ................................................... [–63…+63]
Sets the depth of LFO modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock. J p. 66 “LFO SYNC (LFO Tempo
Sync)”
LFO FREQ (LFO Frequency) .........................................[0.01…100.0Hz]
Sets the LFO speed. J p. 66 “LFO FREQ (LFO Frequency)”
SYNC.NOTE (LFO Sync Note) ..............................................[8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob. J p. 66 “SYNC.NOTE (LFO Sync Note)”
NOTE
This parameter will be displayed and can be set if “LFO SYNC” is ON.
LFO WAVE (LFO Waveform)................[SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects the LFO waveform.
J p. 66 “LFO WAVE (LFO Waveform)”
LFO.SHAPE ......................................................................... [–63…+63]
J p. 66 “LFO.SHAPE”
KEY SYNC (LFO KeySync).............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
J p. 67 “KEY SYNC (LFO KeySync)”
INI.PHASE (LFO Init Phase) .................................................. [000…180°]
Sets the starting location of the waveform.
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is ON.
J p. 67 “INI.PHASE (LFO Init Phase)”
PRE LPF............................................................................... [000…127]
This parameter enables you to set the damping amount of the high range
sound input to the ring modulator. If the input sound contains lots of har-
monics, the effect may sound dirty. In this case, cut a certain amount of
high range.