Filter
Top Products
Effect guide
67
KEY SYNC (LFO KeySync) ............................................................[OFF, ON]
Specifies how the LFO will be reset at note-on.
NOTE
This parameter will be displayed and can be set if “MOD SRC” is LFO.
Note on
Note on Note on
Note all off
With OFF, the LFO phase will not be reset when note-on occurs.
With ON, the first note-on from a condition of no keys being pressed will
reset the LFO to the phase specified by “INI.PHASE,” and modulation will
be applied at that phase even if subsequent note-ons occur.
This takes effect when a note-on occurs on the global MIDI channel.
INI.PHASE (LFO Init Phase)...................................................[000…180°]
Specifies the starting position of the waveform.
With a setting of 0°, the waveform will start from its beginning at note-on.
With a setting of 180°, the waveform will start from the mid-point of its cycle
at note-on.
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is Tim-
bre.
CTRL SRC (Control Source) ...................................[OFF, VELOCITY…MIDI3]
Selects the control source.
The filter will be controlled by the selected source.
NOTE
This parameter will be displayed and can be set if “MOD SRC” is CTRL.
Source Explanation
3. BAND EQ (4Band EQ)
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Band1
Band2
Band3
Band4
PEQ
PEQ PEQ PEQ
LEQ
LEQ
HEQ
HEQ
PEQ
PEQ PEQ PEQ
Trim
Trim
This is a stereo EQ for which the type can be selected independently.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
TRIM................................................................................... [000…127]
Sets the input level of EQ.
OFF Not used
VELOCITY Velocity
P.BEND Pitch bend
MOD.WHEEL Modulation wheel
MIDI1 Source specified by “MIDI1” in Global mode: MIDI
MIDI2 Source specified by “MIDI2” in Global mode: MIDI
MIDI3 Source specified by “MIDI3” in Global mode: MIDI
Effect Guide