Filter
Top Products
Effect guide
73
9. MOD.DELAY (Stereo Modulation Delay)
Left
Right
Feedback
LFO Spread
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Delay
Delay
LFO
This is a stereo modulation delay.
DRY/WET ......................................................["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (Delay Time Tempo Sync)...........................................[OFF, ON]
J p. 70 “BPM SYNC (DelayTime Tempo Sync)”
TM RATIO ................................ [BPM SYNC OFF: 000.5…400.0% (OVER)
/BPM SYNC ON: 012.5…400.0% (OVER)]
J p. 70 “TM RATIO”
L DELAY, R DELAY (L, R Delay Time)................ [000…1400ms, 1/64… 1/1]
J p. 70 “L DELAY, R DELAY (L, R Delay Time)”
FEEDBACK .......................................................................[000…127]
J p. 71 “FEEDBACK”
MOD.DEPTH .....................................................................[000…127]
Sets the depth of LFO modulation.
LFO FREQ (LFO Frequency) ........................................ [0.01…100.0Hz]
Sets the LFO speed. Increasing this value will result in a faster frequency.
LFO SPRD (LFO Spread)...................................................... [–180…180°]
Sets the phase difference between the left and right channels.
10. TAPE.ECHO
Wow Flutter
Tap2 Level
+
Tape
Saturation
Left
Right
Dry / Wet
Trim
Tap1 Level
Dry / Wet
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Feedback
High / Low Damp
Pre Tone
Delay
Spread
This effect simulates a tape echo unit. The distortion and tonal change typi-
cal of magnetic tape are also reproduced.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
BPM SYNC (DelayTime Tempo Sync)............................................[OFF, ON]
J p. 70 “BPM SYNC (DelayTime Tempo Sync)”
TM RATIO ................................[BPM SYNC OFF: 000.5…400.0% (OVER)
/BPM SYNC ON: 012.5…400.0% (OVER)]
J p. 70 “TM RATIO”
TAP1 DLY, TAP2 DLY (Tap1, Tap2 Delay Time)
........................................................... [0000…1400ms, 1/64… 1/1]
Sets the delay times for Tap1 and Tap2.
J p. 70 “L DELAY, R DELAY (L, R Delay Time)”
TAP1 LVL, TAP2 LVL(Tap1Level, Tap2 Level) ........................ [000…127]
Sets the Tap1 output level and Tap2 output level.
FEEDBACK ....................................................................... [000…127]
Sets the Tap1 feedback amount.
HI DAMP ...........................................................................[000…100%]
Sets the damping amount in the high range.
Effect Guide