Filter
Top Products
Effect guide
77
KEY SYNC (LFO KeySync) ............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
J p. 67 “KEY SYNC (LFO KeySync)”
INI.PHASE (LFO Init Phase)...................................................[000…180°]
Sets the starting location of the waveform.
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is ON.
J p. 67 “INI.PHASE (LFO Init Phase)”
LFO SPRD (LFO Spread)....................................................[–180…+180°]
Sets the LFO phase difference between the left and right channels.
HI DAMP ...........................................................................[000…100%]
Sets the feedback damping amount in the high range.
15. TREMOLO (Stereo Tremolo)
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO Spread
LFO
LFO Shape
Tremolo
Tremolo
This effect modulates the volume level of the input signal. The effect is ste-
reo, and offsetting the LFO of the left and right phases from each other pro-
duces a tremolo effect between left and right.
DRY/WET ......................................................["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
MOD.DEPTH (Modulation Depth) .......................................[000…127]
Sets the depth of LFO modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
J p. 66 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) .........................................[0.01…100.0Hz]
Sets the LFO speed.
J p. 66 “LFO FREQ (LFO Frequency)”
SYNC.NOTE (LFO Sync Note) ..............................................[8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob.
NOTE
This parameter will be displayed and can be set if “LFO SYNC” is ON.
J p. 66 “SYNC.NOTE (LFO Sync Note)”
LFO WAVE (LFO Waveform)................[SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects the LFO waveform.
J p. 66 “LFO WAVE (LFO Waveform)”
LFO.SHAPE ......................................................................... [–63…+63]
J p. 66 “LFO.SHAPE”
KEY SYNC (LFO KeySync).............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
J p. 67 “KEY SYNC (LFO KeySync)”
INI.PHASE (LFO Init Phase) .................................................. [000…180°]
Sets the starting location of the waveform.
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is ON.
J p. 67 “INI.PHASE (LFO Init Phase)”
LFO SPRD (LFO Spread)....................................................[–180…+180°]
Sets the LFO phase difference between the left and right channels.
16. RING MOD (Stereo Ring Modulator)
This effect creates a metallic sound by applying the oscillators to the input
signal. Use the LFO or Dynamic Modulation to modulate the oscillator to
create a radical modulation. Matching the oscillator frequency with a note
number will produce a ring modulation effect in specific key ranges.
Effect Guide