Filter
Top Products
Effect guide
75
DELAY ...................................................................... [00.0…30.0ms]
Sets the delay time in millisecond steps.
MOD.DEPTH (Modulation Depth) .......................................[000…127]
Sets the depth of LFO modulation.
FEEDBACK .......................................................................[000…127]
Sets the amount of feedback for the left and right channels.
PHASE ..........................................................................................[+, –]
This switches the phase of the output and feedback.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
J p. 66 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) ........................................ [0.01…100.0Hz]
Sets the LFO speed.
J p. 66 “LFO FREQ (LFO Frequency)”
SYNC.NOTE (LFO Sync Note) .............................................. [8/1…1/64]
Sets the LFO frequency as a proportion of the tempo set by the [TEMPO]
knob. J p. 66 “SYNC.NOTE (LFO Sync Note)”
NOTE
This parameter will be displayed and can be set if “LFO SYNC” is ON.
LFO WAVE (LFO Waveform) ............... [SAW, SQUARE, TRIANGLE, SINE, S&H]
Selects LFO Waveform. J p. 66 “LFO WAVE (LFO Waveform)”
LFO.SHAPE..........................................................................[–63…+63]
J p. 66 “LFO.SHAPE”
KEY SYNC (LFO KeySync) ............................................................[OFF, ON]
Specifies whether the LFO will be reset by note-on.
J p. 67 “KEY SYNC (LFO KeySync)”
INI.PHASE (LFO Init Phase)...................................................[000…180°]
Sets the starting location of the waveform. J p. 67 “INI.PHASE (LFO Init
Phase)”
NOTE
This parameter will be displayed and can be set if “KEY SYNC” is ON.
LFO SPRD (LFO Spread)....................................................[–180…+180°]
Sets the LFO phase difference between the left and right channels.
HI DAMP (High Damp) ........................................................[000…100%]
Sets the feedback damping amount in the high range.
13. VIBRATO (Stereo Vibrato)
Vibrato
Vibrato
Left
Right
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
LFO
LFO Shape
LFO Spread
This effect causes the pitch of the input signal to shimmer. Using the Auto-
Fade allows you to increase or decrease the shimmering speed.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
MOD.DEPTH (Modulation Depth) ...................................... [000…127]
Sets the depth of LFO modulation.
LFO SYNC (LFO Tempo Sync) .......................................................[OFF, ON]
Specifies whether the LFO cycle will be synchronized with the tempo speci-
fied by the [TEMPO] knob or MIDI clock.
J p. 66 “LFO SYNC (LFO Tempo Sync)”
LFO FREQ (LFO Frequency) .........................................[0.01…100.0Hz]
Sets the LFO speed.
J p. 66 “LFO FREQ (LFO Frequency)”
Effect Guide