Filter
Top Products
microKORG XL
74
LO DAMP...........................................................................[000…100%]
Sets the damping amount in the low range.
TRIM ...................................................................................[000…127]
Sets the input level.
SATURATN (Tape Saturation) .............................................[000…127]
Sets the distortion amount.
WOW.FREQ (Wow Flutter Frequency) ............................. [0.01…100.0Hz]
Sets the frequency at which pitch variation will occur in Hz steps.
WOW.DEPTH (Wow Flutter Depth) .........................................[000…127]
Sets the depth of pitch variation.
PRE TONE.............................................................................[000…127]
Sets the tone of the input.
SPREAD ...............................................................................[000…127]
Sets the width of the stereo image of the effect sound.
J p. 71 “SPREAD”
11. CHORUS (Stereo Chorus)
Chorus
Chorus
Left
Right
LFO Spread
Dry / Wet
Dry / Wet
Stereo In - Stereo Out
Trim
Trim
HEQ
HEQ
LFO
This effect adds thickness and warmth to the sound by modulating the
delay time of the input signal. You can add spread to the sound by offsetting
the phase of the left and right LFOs from each other.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.
MOD.DEPTH (Modulation Depth) ...................................... [000…127]
Sets the depth of LFO modulation.
LFO FREQ (LFO Frequency) .........................................[0.01…100.0Hz]
Sets the LFO speed. Increasing this value will result in a faster frequency.
LFO SPRD (LFO Spread)......................................................[–180…180°]
Sets the LFO phase difference between the left and right.
PRE DLY L, PRE DLY R(Pre Delay L, Pre Delay R) .................[00.0…50.0ms]
Sets the delay times for the left and right channels.
TRIM................................................................................... [000…127]
Sets the input level.
HI.EQ.GAIN (High EQ Gain) ..........................................[–15.0…+15.0dB]
Sets the gain of High EQ.
12. FLANGER (Stereo Flanger)
Flanger
Flanger
Left
Right
Feedback
LFO Shape
LFO Spread
LFO
Dry / Wet
Dry / Wet
High Damp (Type: Flanger)
Stereo In - Stereo Out
This effect gives a significant swell and movement of pitch to the sound. It
is more effective when applied to a sound with a lot of harmonics. This is a
stereo flanger.
DRY/WET...................................................... ["DRY", 99:1…1:99, "WET"]
Sets the balance between the effect and dry sounds.