Filter
Top Products
HMP Release 2.0 for Windows Software Installation Guide — December 2005 9
1
1.Installation Overview
This chapter provides the following information about installing Intel NetStructure
®
Host Media
Processing (HMP) Software Release 2.0 for Windows.
• Choosing the Appropriate Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
• Major Installation Steps. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
• HMP Licenses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
1.1 Choosing the Appropriate Installation Procedure
You can perform either a full or update install of the HMP Release 2.0 software. The installation
procedure you use depends on what is on your system. Table 1 shows the various installation
scenarios. In all cases, you must meet the relevant prerequisites described in Section 2.1,
“Prerequisites for Software Installation”, on page 13. The installation procedures listed in the table
are links to the sections containing the procedures.
Note: The update install gives you the latest software for the features that you selected when you did the
full install of the release that is currently on your system. If you want an additional feature that
wasn’t previously installed (for example, Demos), first perform the update install and then perform
the procedure in Section 2.7, “Adding or Removing Installed Features”, on page 31.
Table 1. Installation Scenarios
If you have this on your system Use this installation procedure
No existing HMP Software Section 2.3, “Performing a Full Install of the Software”, on page 20
or
Section 2.5, “Performing a Silent Install”, on page 25
A previous version of HMP Release
2.0
Section 2.4, “Performing an Update Install”, on page 23
or
Section 2.5, “Performing a Silent Install”, on page 25
HMP Release 1.3 or HMP Release
1.1
Section 2.3, “Performing a Full Install of the Software”, on page 20
or
Section 2.5, “Performing a Silent Install”, on page 25
Note: You must uninstall HMP Release 1.3 or HMP Release 1.1
before installing HMP Release 2.0. Refer to Section 2.1.1,
“Uninstalling a Previous Release”, on page 14.
HMP Release 1.1 with a Feature
Pack and/or Service Pack
Section 2.3, “Performing a Full Install of the Software”, on page 20
or
Section 2.5, “Performing a Silent Install”, on page 25
Note: You must uninstall HMP Release 1.1 and the Feature Pack
and/or Service Pack before installing HMP Release 2.0. Refer
to Section 2.1.1, “Uninstalling a Previous Release”, on page 14.