Filter
Top Products
42 HMP Release 2.0 for Windows Software Installation Guide — December 2005
Troubleshooting
2. Select System. The System Properties window opens.
3. On the System Properties window, select the Hardware tab.
4. On the Hardware tab, click the Driver Signing button. The Driver Signing Options window
opens.
5. On the Driver Signing Options window, note what the current setting is (Warn, Block, or
Ignore).
6. If the setting is Warn or Block, change the setting to Ignore (see Figure 10).
Figure 10. Driver Signing Options Window
7. Click OK and close the Control Panel.
8. After you install the HMP Software, go back to the Driver Signing Options window and
change the setting back to the original setting you noted in Step 5.
4.6 Board Detection Fails When a Board is Installed
After the HMP Software
Normally, if you install a board on a system that already has HMP software installed on it, the
“Found New Hardware Wizard” will appear after you install the board and reboot the system. In