Filter
Top Products
HMP Release 2.0 for Windows Software Installation Guide — December 2005 33
Installing the Software
(If you choose to reboot later you must manually reboot the system before the install will be
complete.) If you inserted a CD to add features, remove it from the drive. Click Finish to
proceed.
7. Start the system. The HMP system is started using the configuration manager (DCM). From
the DCM main window, click the Start System option from the System pull-down menu or
click the Start All Enabled Devices icon.
2.7.2 Rerunning the Setup Program
To add and/or remove programs by rerunning the setup program, follow this procedure:
1. If HMP is currently running, close all telephony applications that are currently running in the
system and stop the system. The HMP system is stopped using the configuration manager
(DCM).
From the DCM main window, click the Stop System option from the System pull-
down menu or click the Stop All Enabled Devices icon. Then close DCM by clicking the
close button at the upper right corner of the DCM window.
Note: Make sure you also perform the above step and close the DCM from every remote
connection (if applicable).
If you do not stop the HMP system, setup will automatically stop the HMP system. However,
if DCM is still open, setup will inform you (with a popup message, see Figure 8) that it is
open, and exit. At that point, you can close DCM and restart the installation procedure (to add
or remove features).
2. Rerun the setup program by doing one of the following:
• Insert the CD-ROM with the HMP Release 2.0 software and select Install Intel
®
Software from the navigation screen.
• Locate and run the setup.exe file for HMP Release 2.0.
3. An InstallShield* Wizard screen appears (Figure 5).