Filter
Top Products
HMP Release 2.0 for Windows Software Installation Guide — December 2005 15
Installing the Software
2.1.2 Installing and Configuring Windows SNMP Service
If you intend to use the SNMP agent software (for a description, see Section 2.1.4, “Determining
Which Features to Install”, on page 17) and Windows SNMP Service has not already been
installed, you must install and configure the Windows SNMP Service on both the managed node
and the network management station before installing the HMP Software release and SNMP agent
software.
Note: If you uninstall and reinstall the Windows SNMP Service on the managed node, you will also have
to uninstall and reinstall SNMP agent software.
Installing SNMP Service
The following steps describe how to install Windows SNMP service:
1. Invoke the Control Panel.
2. Select Add or Remove Programs.
3. Select Add/Remove Windows Components. The Windows Component Wizard is displayed.
4. Check the Management and Monitoring Tools box.
5. Click the Details button.
6. Check the Simple Network Management Protocol box and click OK. The Windows
Component Wizard is redisplayed.
7. Click Next. You may be asked to insert the operating system CD. Proceed through the
Windows Component Wizard until it has finished.
Note: If your system has had a Windows service pack installed on it, you should reinstall the Windows
service pack after installing SNMP service.
Configuring SNMP Service
Follow the steps below to configure Windows SNMP Service:
1. Invoke the Control Panel.
2. Select Administrative Tools.
3. Select Services.
4. Select SNMP Service.
5. Choose the Agent tab.
6. Enter Contact and Location.