GTO GP-SW050 Safety Gate User Manual


  Open as PDF
of 37
 
25
Reinstalling the Operator Housing
Checktomakesurethesafetyedges,photoelectricbeams,warningsigns,andpedestriangate(ifnecessary)are
installed (see pages 5-6) before fastening the housing to the operator.
Theinstallationiscomplete.Testtheoperator,accessories,andsafetydevicesforcorrectfunction.Readand
ll out the INSTALLATION CHECKLIST on the back cover of this manual.
1. Lower the operator housing into
position over the operator.
Allen Bolts
with 5mm key
Washers
2. Pull sides out slightly so that the
housing sits into place properly over the base.
3. Fasten the housingtotheoperatorwith
(2)Washersand(2)AllenBolts.
 previous next