GTO GP-SW050 Safety Gate User Manual


  Open as PDF
of 37
 
24
Prison Mode Operation (CLASS IV APPLICATIONS)
Prison mode operation means that constant pressure at the CLOSE or the OPEN push button station
input is required to move the gate in the desired direction.
Follow these steps to toggle the PRISON MODE operation on/o:
1. Powerdowntheunit.
2. Press and hold the OPEN and CLOSEpushbuttonwhilepoweringontheunit.
3. The PRISON MODE LEDindicatorwillbeonifoperatinginprisonmode.
4. Repeattheabovestepstoturnoprisonmodeoperation.
Press and hold at power up to toggle
to prison mode.
COM
COM
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
LIMIT ADJUSTMENTS
TEST SWITCHES
CLOSE STOP OPEN
GTO Inc. Tallahassee, FL
SX4000 Logic Board Rev. E
MIN MAX MIN MAX OFF 120
<<<
JOG
>>>
<<<
>>>
SET
LIMIT
W1
CUT TO USE
3 BUTTON
STATION
COM COM
AUTO CLOSE
TIMER
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
STOP
W1
CUT TO USE
3 BUTTON
STATION
Wiring a 3-button station
CYCLE
SAFETY
OPEN EDGE
CLOSE EDGE
OPEN
CLOSE
STOP
COM
COM
COM
SHADOW
LOOP
OPEN
CLOSE
STOP
NOTE: The W1 Jumper must be cut in order
to use a 3-button station.
To restore normal operation of cut jumper
youmustconnectawirebetweenthe
STOP and COM terminals (or you could use
anormallyclosedpush-button).Thiswire
functions the same as the W1 jumper.
COM
COM
COM
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
W1
CUT TO USE
3 BUTTON
STATION
 previous next