GTO GP-SW050 Safety Gate User Manual


  Open as PDF
of 37
 
12
Removing the Operator Housing
Beforeyoucangainaccesstotheoperatorframeanditsmountingholes,thehousingwillhavetobe
removed from the operator.
1.  Removethe(2)3/8”allenboltsand(2)m8washersfromtheoperatorhousing(thishardwareis
located on each side of the housing).
2. Lift the housing o the operator and set it aside.
Allen Bolts
with 5mm key
Washers
Mounting the Operator
1.  Lifttheoperatorandalignitsmountingholesoverthe3/8”diameterconcretemountinganchors.
2.  Lowertheoperatorintopositionandfastenittothemountinganchorswith(4)3/8”washersand
nuts (not provided).
 previous next