GTO GP-SW050 Safety Gate User Manual


  Open as PDF
of 37
 
18
Stall Force and Auto-Close Adjustments
Stall Force Adjustment:
IMPORTANT: For safety reasons, the STALL FORCE potentiometers are set at the “10 o’clock” position
at the factory.
The obstruction sensitivity is independently adjustable for each direction of travel. Upon sensing an
obstruction,thegatewillstopandreversedirectionforapproximately2seconds.
1. Turningthepotentiometerclockwise(towardtheMAXposition)increasestheamountofforce
theoperatorappliestoanobstruction.Turningthepotentiometercounter-clockwise(towardthe
MINposition)decreasestheamountofforcetheoperatorappliestoanobstruction.
2. Useasmallscrewdrivertoadjusttheappropriatepotentiometerandoperatethegateuntilitcan
runwithoutobstructingandreversingdirection.
1 2 3 4
ON
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
STALL FORCE ADJUST
LIMIT ADJUSTMENTS
DIAG.
PORT
RUNNING
OPTIONS
MIN MAX MIN MAX OFF 120
<<<
JOG
>>>
<<<
>>>
SET
LIMIT
CLOSED
LED10
LED09
AUTO CLOSE
TIMER
MODE 1
MODE 2
OPEN DIR.
SLV OPN
DUAL MODE
LOW BATT
ON
ON
>>>
SIMUL
SLAVE
SECURE
OFF
OFF
<<<
DELAY
MASTER
SAFE
CYCLE
SAFETY
OPEN EDGE
RUN 2
OPEN
CLOSE
STOP
COM
COM
COM
SHADOW
LOOP
RELAY OUTPUTS
LOCK N.C.
LOCK COM
LOCK N.O.
RUN 1
RUN 2
CLOSED 1
CLOSED 2
1 2 3 4
ON
CYCLE
SAFETY
SHADOW
OPEN
CLOSE
STOP
OPEN
EDGE
CLOSE
EDGE
STALL FORCE ADJUST
LIMIT ADJUSTMENTS
DIAG.
PORT
RUNNING
MIN MAX MIN MAX OFF 120
<<<
JOG
>>>
<<<
>>>
SET
LIMIT
CLOSED
LED10
LED09
SAFETY
SHADOW
OPEN
EDGE
CLOSE
EDGE
OPEN
CLOSE
STOP
COM
AUTO CLOSE
TIMER
Auto-Close Adjustment:
The Auto-Closepotentiometerallowstheusertosetthetimethatthegatewillstayattheopen
position/limit before it automatically starts to close the gate.
This feature can be turned o by turning the AUTO CLOSE TIMER potentiometeralltheway
counter-clockwise.ItisshippedfromthefactoryintheOFFposition(autoclosefeatureisdisabled).
• Theautoclosetimeisadjustablefrom3-120seconds.
• Thisfeatureisonlyenabledwhenthegateisattheopenlimit.
• Thisfeatureisdisabledifthefollowinginputsareactivated.
• OPEN,SAFETY,SHADOW,CLS-EDGEorSTOP.
 previous next