Filter
Top Products
65
OWNER’S MANUAL
Count up timer
Flowchart for Ventilation Pump Failure During Ventilation Cycle
12 (or 24) HOUR CYCLE
STERILIZING
1:53:15 REMAINING
VENTILATING BAG
0:20:12 REMAINING
UNLOAD STERILIZER
VENT PUMP FAILURE
00:02:55
EXIT
VENTILATING BAG
VENT PUMP FAILURE
0:20:01 REMAINING
ALARM OFF
If a VENT PUMP FAILURE occurs during
ventilation cycle, the screen will display the
error message, and beep continuously until
the ALARM button is pressed. The purge
pump will remain on for the remainder of
the normal cycle time and will ventilate the
cabinet.
VENT PUMP FAILURE
REFER TO ERROR
SECTION OF MANUAL
In this case, sterilization has been com-
pleted prior to the failure of the pump.
ITEMS IN THE LINER BAG MAY BE
CONSIDERED STERILE
Refer to the Error and Troubleshooting sections of
the manual for information about repairing the
sterilizer
To reset the machine, shut off the machine power.
Then, while holding both buttons, turn on the
power. Release buttons after the display shows
characters.
The machine may be unloaded once the
counter reaches 0:00:00, and the items may be
used normally
AN74 I
ANPROLENE STERILIZER
START
Press ALARM OFF
to stop the alarm
RESET
© Andersen Products Ltd