Filter
Top Products
50
OWNER’S MANUAL
Confirm that you have the following items:
• ΑΝ74 i/ix
Anprolene sterilizer upper and lower cabinet unit
• (A) Eight toggle inserts and Phillips screws to secure the
mounting plates.
• (B) Exterior wall mounting plate with black plastic bushing.
• (C) Eight foot length of 3/4" (1.9 cm) I.D. clear braided PVC
tubing and two stainless hose clamps (included with sterilizer).
• (D) Interior wall mounting plate with 90° elbow fitting
assembly and 20" (50.8 cm) length of black 3/4" (1.9 cm) I.D.
tubing for through wall penetration
• (E) Owner’s Manual
C.3 Temporarily position the sterilization cabinet in the appropriate location, as described
in Appendix B.
APPENDIX C
Installation Instructions for New Anprolene Users
C.1 Unpacking - The combined upper and lower sterilization cabinet weighs
approximately 50.5 pounds / 60.5 pounds. To avoid possible injury, it is recommended that
two persons assist in removing the sterilizer from the shipping box and placing the sterilizer
wherever it will be used.
To unpack the sterilizer, gently turn the packing box upside down on the floor. Next, slit the
tape along the center edges of the bottom flaps and fold all four flaps down against the sides
of the box. Leave the bottom foam packing insert in place and turn the packing box back to
its original upright position. Pull the box up and off of the sterilizer. Remove the top foam
packing insert.
Each side of the painted steel enclosure has a turned under bottom edge that is raised up off
the ground approximately 3/4” (1.9 cm). One person should now take hold of the left bot-
tom edge while the other takes hold of the bottom edge on the opposite side of the sterilizer
and lift it up out of the bottom foam insert and place the sterilizer on the counter surface
where the unit is to be installed.
C.2 The following tools will be needed for installation of the sterilizer:
• Electric drill
• 3/8” (0.95 cm) drill for the toggles
• 1/4” to 3/8” diameter drill bit that is longer than the exterior wall is thick
• 2” (5.08 cm) hole saw
• Medium flat blade screwdriver
• Medium Phillips screwdriver
• Razor knife, and
• Soapy water solution in a squirt bottle for leak testing.
© Andersen Products Ltd