Filter
Top Products
57
OWNER’S MANUAL
D.2.1 Clean the Mating Surfaces. Remove the mounting plate from the
wall and clean the outside surface of the 2” PVC pipe as well as the interior
surface of the tube extending from the back of the plate with rubbing alcohol
and allow to dry.
D.2.4 Secure the Mounting Plate to the Wall. Screw the mounting plate to
the wall using the original 4 small screws.
Section D.2. Securing the PVC
D.3.1 Before inserting the PVC adaptor, test the fit by placing the adaptor
into the hole. If necessary, clean the mating surfaces with rubbing alcohol.
Section D.3. Inserting the PVC Adaptor
D.2.2 Correct Position of the Wall Plate. After the PVC glue is applied as
detailed in the next paragraph, you must quickly slide the mounting plate all
the way onto the pipe until it bottoms out against the lip of the mounting
plate. Then you must immediately align the four holes in the mounting plate
with the four mounting toggle holes in the wall by rotating the mounting
plate as needed.
D.3.2 Apply a thin film of PVC glue to each of the mating surfaces, includ-
ing the inside of the 2” PVC pipe.
D.2.3 Gluing the Wall Plate to the PVC Tube. Apply a thin film of PVC
glue to each of the mating surfaces. QUICKLY press the wall plate onto
the PVC pipe. The glue acts as a lubricant, so it will easily slide in. NOTE:
There can be no delay in sliding the wall plate onto the pipe after apply-
ing the glue. The glue dries in seconds and any delay may prevent cor-
rect alignment. Wipe off any excess PVC glue from the interior of the pipe
with a paper towel
© Andersen Products Ltd