Filter
Top Products
MX49/MX61 Owner’s Manual
Quick Guide
19
Selecting a Voice for Part 2
Here, you’ll learn how to select a Voice for Part 2 as well
as Part 1. By setting the Voices of Part 1 and Part 2 in the
top display, you can alternate between the two Voices as
you play without the sound unnaturally cutting off.
1 Press the Cursor [ ] button to select Part 2.
Only Part 2 can now be sounded.
2 Press the desired Voice Category button.
3 Rotate the [DATA] dial to select a specific
desired Voice in the selected category.
4 Play the keyboard.
5 While playing the keyboard, press the Cursor
[ ] button to select Part 1.
The Part 2 sound is maintained for the last key
played, and the Voice changes to that of Part 1, which
plays from the next key and after.
Combining Voices (Layer)
You can select separate Voices for Parts 1 and 2, and
play both Voices together in a layer.
1 Press [LAYER].
Part 1 and Part 2 can now be sounded at the same
time (Layer). In the display, Part 2 is selected.
2 Use the Category buttons and the [DATA] dial
to select a Voice for Part 2, and check the
sound by playing the keyboard.
NOTE To change the Voice for Part 1, press the Cursor [ ]
button to select Part 1, then use the Category buttons
and the [DATA] dial to select a different Voice.
HINT
Stopping Arpeggio playback
Depending on the selected Voice, you can trigger
Arpeggio playback by playing the keyboard. To stop
Arpeggio playback at any time, press [ARP]. To
enable the Arpeggio function again, press [ARP] so
that the lamp lights.
KB
STR:081:Amb
*
Pizza
:004:Soft*Case
c
KB
ORG:001:16+8+5&1/3
:004:Soft*Case
c
Voice for Part 2 is changed.
Voice for Part 1
Voice for Part 2
KB
ORG:002:Jz2Perc+C3
:004:Soft*Case
c
Voice for Part 2 is changed.