Filter
Top Products
MX49/MX61 Owner’s Manual
13
Power supply
Make connections for the supplied power adaptor
(page 44) in the following order. Before you connect the
power adaptor, make sure that the power of this
instrument is set to Standby status ( ).
1 Wrap the DC output cable of the power
adaptor around the cable clip (as shown
below), then connect the plug of the adaptor
to the DC IN jack on the rear panel.
NOTE Use of the cable clip prevents accidental unplugging of the
cable during operation. Make sure to avoid tightening the
cord more than necessary or pulling on the cord strongly
while it is wrapped around the cable clip to prevent wear on
the cord or possible breakage of the clip.
2 Connect the other end of the power adaptor
to an AC outlet.
NOTE Follow this procedure in reverse order when disconnecting
the power adaptor.
WARNING
Use only the specified adaptor (page 44). The use of other
adaptors may result in irreparable damage to both the
adaptor and the instrument.
CAUTION
Even when the power of this instrument is in the Standby
status, electricity is still flowing to the instrument at the
minimum level. When you are not using the instrument for a
long time, make sure you unplug the power adaptor from the
wall AC outlet.
Connecting speakers or
headphones
Since this instrument has no built-in speakers, you will
need to monitor the sound of the instrument by using
external equipment. Connect a set of headphones,
powered speakers, or other playback equipment as
illustrated below. When making connections, be sure that
your cables have the appropriate ratings.
NOTICE
Before connecting this instrument to external devices, turn
off the power to all the devices.
Powering up the system
Make sure the volume settings of this instrument and
external devices such as powered speakers are turned
down to the minimum before turning the power on. When
connecting this instrument to the powered speakers, turn
on the power switch of each device in the following order.
When turning the power on:
First, turn the power of the MX49/MX61 on with the
(Standby/On) switch, then turn the power of the
connected powered speakers on.
When turning the power off:
First, turn the power of the connected powered speakers
off, then turn the power of the MX49/MX61 off with the
(Standby/On) switch.
Setting Up
Power adaptor
AC outlet
MX49/MX61
Powered speaker
(Left)
Powered speaker
(Right)
OUTPUT [L/MONO] OUTPUT [R]
Headphones
[PHONES]
Standard mono phone
plugs
Standard stereo phone plug
MX49/MX61
Standby/On switch DC IN